SightTracker
VMS Instructions
Note: The instructions provided below are based on the most recently tested version of the VMS system; some changes may have occured. They are also are intended for knowledgeable users who have been trained in the VMS system that is being used.
VMS System | Tested Version | Special Notes | Setup Instructions |
| Aimetis Senstar Symphony | 7.1.0.1 | Firmware 15.10 and above | |
| Avigilon Control Center 6 | 6.8.4.0 | Click Here | |
| Avigilon Control Center 7 | 7.2.0.18 | Click Here | |
| Bosch | 7.5 | Click Here | |
| CHeKT Bridge | 2.5.x | Click Here | |
| Exacq Vision | 9.2.3.130093 | Set "Disable RTCP Timeout" to Enabled | Click Here |
| Flir Latitude | 8.0.0.6100 | Click Here | |
| Genetec Security Center | 5.10.0.0 (357.0) | In Genetec, select ONVIF as manufacturer when adding the camera. | Click Here |
| IndigoVision | 15.1 | Click Here | |
| Luxriot EVO | 1.6.0.20768 | Click Here | |
| March Networks Command Pro | 2.1.0.63 | Click Here | |
| Milestone Xprotect | 2020 R3, 20.3a | Click Here | |
| OpenEye | 1.8.0.8271 | Requires Firmware 16.2.12 | Click Here |
| Qognify | Cayuga R17 | Use the camera driver ONVIF Profile-S/G Driver | Click Here Select "SightLogix" from the Manufacturer drop-down menu |
| SureView Immix | Click Here
|