-
Last Updated: 09/11/2018
in How To's If a SightLogix device is powered up on a network with dynamic addressing (DHCP service), it may be difficult to find which IP address has been assigned to a particular device. In this case, you can use ONVIF Device Manager (ODM ) to discover the IP...
-
These instructions are for SightSensor HD only. If you have been using SightMonitor to manage your SightSensor(s), and you want to change your configuration method to using WebConfig, follow these steps. Note: SightSensors should be managed eith...
-
Last Updated: 04/11/2018
in General Information 3rd Generation SightSensors provide an LED indicator which is used to describe boot progress. Normal LED Progression After applying power to a c amera, the normal LED sequence is: Solid Red The camera has power and is trying to load the...
-
Last Updated: 11/14/2017
in How To's If your SightTracker has been configured to work with a particular IP PTZ, and you want to change to a different IP PTZ, you must first Factory Reset the SightTracker before adding the new PTZ camera. Follow instructions here: http://portal.sigh...
-
Last Updated: 04/27/2017
in How To's Follow these instructions when replacing an existing 3rd Gen SightSensor for a new SightSensor that ends with -x20 part numbers. You can find your part number on the sticker outside of your new SightSensor. Note that newer 3 rd Generation SightSe...
-
Last Updated: 01/12/2017
in General Information SightLogix announced the End of Life (EOL) for Second Generation (Gen2) SightSensors in May, 2015. In response, we have created a cost-effective Gen2 to Gen3 Upgrade Program for customers who would like to replace their existing Gen2 SightSensors...
-
Last Updated: 02/23/2016
in How To's Below are instructions to back up the SightLogix SightMonitor database.
In SightMonitor, select "Edit" > "Backup data base now"
Once done, should have a new directory in
C:\Program Files\sightlogix\cs\db\backups with ...
-
Last Updated: 09/03/2015
in Troubleshooting Overview:
3rd Generation SightLogix devices do not presently support auto network line reversal negotiation.
Solution
If a SightLogix device is running and the network cable is disconnected and re-connected directly to a laptop, it wi...
-
Last Updated: 09/03/2015
in How To's Follow these instructions to swap an existing SightTracker that is in need of replacement.
Make note of the serial number of the new Sight Tracker
Set networking IP addrerss, gateway, mask and NTP on new Sight Tracker to same settings ...
-
Last Updated: 05/08/2025